Weber IDF - How to set the float level
 |
|
Weber IDF - How to set the float level
|
Weber IDF Float Setting Instructions
On this page you will find brief instructions on how to correctly set the float in the Weber IDF carburettors.
To set the float level, you need to assemble the top cover, needle valve, float pivot pin and the float itself.
Please note:
Do NOT install the top cover gasket !
Next, keep the cover vertically like in the drawing, with the float pivot pin at the top.
The float bracket should lightly touch the needle valve without the ball being depressed.
Now measure the distance from the float to the cover.
This distance should be 10.0 mm.
When necessary, bend tab Number 6 to adjust this distance.
Next, keep the top cover horizontally with the float at full drop.
Again, measure the distance.
This should now be 32.5 mm
When necessary, bend tab Number 3 to adjust this distance.
Recheck the "vertical distance" and adjust when necessary.
This should now give a total working stroke of 22.5 mm.
That is all there is to it but please don't forget to assemble the top cover gasket!
In order to reduce the download time, and hence the time that you spend waiting for all the data and images to download, we have reduced the maximum number of items per page to 24.
This can mean that the item that you are looking for is located on a "next page".
This is an example of what that can look like:
In that case, please use the "<Previous" en "Next>" buttons to zip through the pages.
All products on our website are in stock and ready to be shipped unless clearly indicated otherwise !
Dellorto, Weber, Mikuni, Aisan, Keihin, Edelbrock and Solex Carburettors Spare Parts Jets Chokes Emulsion Tubes Service Kits