47407.027
Pump Diaphragm with spring-loaded tip for a Weber IDF carburetor.

Please note that the IDF can be equipped with two kinds of diaphragm where the difference is in the tip of the cam.

This is the version with the brass, spring-loaded, tip.

The cam, including the (non-compressed!) spring-loaded tip, measures 12.7 mm from the surface of the top disc.

The diameter of both the top disc and bottom disc is 25.4 mm.

The bolt hole spacing is roughly 44 mm, heart-to-heart, measured diagonally.

The other version with the solid tip can be found HERE.

Unfortunately, there is no rule of thumb on which IDF takes which diaphragm so you will have to open up the pump to verify which version you need.

Please note that the versions are NOT interchangeable!

This product is priced, and sold, as a single unit.
Required quantity per carburettor: 1

This is item number 33 in the drawing of the Weber IDF carburetor.

This is Weber Part Number: 47407.027

Operating principles of the acceleration pump and the role of the diaphragm in this:

This diaphragm is activated by a lever that is connected to the throttle lever(s).

When releasing the throttle, a spring returns the diaphragm to its initial position and by doing so, it sucks-in fuel from the float chamber.
A one-way valve prevents this fuel from leaking back into the valve chamber.

When you then activate throttle, that same lever pushes the diaphragm inwards and the pressure that is thus created makes the fuel being squirted downstream with the main airflow through the pump jet.

This extra flow of fuel will prevent "fuel starvation" from occurring when the throttle is suddenly opened which allows large quantities of air being sucked into the engine.

When you then release the throttle again, the diaphragm is again pushed back by the spring, thus priming the pump chamber with a fresh supply of fuel and making it ready to repeat the procedure.

This is an excellent system that has been employed for decades by various makes of carburetors and applied to all kinds of applications.
So, not only Weber but also Solex, Pierburg, Zenith and Mikuni used this system with more or less identical operating principles.

However, to ascertain a flawless operation of this system, the diaphragm need to be in excellent condition.

The original diaphragms are now coming of age and are suffering from the ravages of aggressive modern fuels which causes the "rubberized textile" material to harden or even crack, causing erratic running of the engine and fuel leaks.

Replacing the diaphragm is then the only sensible option which is a rather simple operation.

A complete overview of our pump diaphragms for Weber carburettors can be found HERE.