32cm long Reamer - 8.2mm

tools
reamerlong
9506557445635
    Delivery time: In stock and ready to ship
Add to cart
  • Description
  • More

reamerlong
Everybody who considers himself to be a serious mechanic, will be familiar with the phenomenon of "worn throttle shaft bores" and the need to correct that.

32cm Reamer - 8.2mm

This phenomenon that manifests itself mainly in carburettors which have no shaft bearings and where a hardened steel, or bronze, shaft runs directly into the soft "Zamac" alloy body and where decades of use have worn out the bores which allow the shafts to move erratically thus making the carburettors virtually impossible to tune or set-up correctly.

Those throttle shafts are usually 8.0 mm in diameter.

For some carburettor models, this issue can be countered by replacing the shaft(s) with an over-sized 8.2 mm version which will "absorb" the wear.

The challenge is then to ream the bore in the body casting to that 8.2 millimeter to make the thicker shaft fit the body.

For this purpose, we can now offer these reamers with a working length of roughly 32 cm which suffices for most 3-Barrel carburettors but please check if this is enough for your carburettor.

32cm Reamer - 8.2mm

This product is priced and sold as a single unit.

This is Our Article Number: reamerlong

Reamer 32cm long - 8.2mm

Reamer 32cm long - 8.2mm

reamerlong
Everybody who considers himself to be a serious mechanic, will be familiar with the phenomenon of "worn throttle shaft bores" and the need to correct that.

This phenomenon that manifests itself mainly in carburettors which have no shaft bearings and where a hardened steel, or bronze, shaft runs directly into the soft "Zamac" alloy body and where decades of use have worn out the bores which allow the shafts to move erratically thus making the carburettors virtually impossible to tune or set-up correctly.

Those throttle shafts are usually 8.0 mm in diameter.

For some carburettor models, this issue can be countered by replacing the shaft(s) with an over-sized 8.2 mm version which will "absorb" the wear.

The challenge is then to ream the bore in the body casting to that 8.2 millimeter to make the thicker shaft fit the body.

For this purpose, we can now offer these reamers with a working length of roughly 32 cm which suffices for most 3-Barrel carburettors but please check if this is enough for your carburettor.

This product is priced and sold as a single unit.

This is Our Article Number: reamerlong


Reamer 32cm long - 8.2mm

Reamer 32cm long - 8.2mm

!